POF-USA factory replacement firing pin. Two options are available for purchase. One is for mil-spec AR's and the other is for our P-308 bolt carrier groups.
OEM replacement Mil-spec Firing Pin Retaining Pin kit. Packaged and shipped in sets of 5. These cotter pins fit all POF-USA bolt carrier group assemblies.
Our Muzzle Devices are available in 1/2X28 AND 5/8X24 threads. Each device includes a pre-drilled pin hole to make permanently attaching this muzzle device a breeze. Comes complete with a nitride heat treated Collar Jam Nut
OEM replacement forward assist retaining pin. This pin will fit in any POF-USA AR-15 upper receiver and P-308 upper receivers. It is NOT Compatible with Revolution PD or Revolution DI upper receivers. Revolution PD and Revolution DI upper receivers use a threaded screw to secure the forward assist.
OEM replacement mil-spec spring. It is compatible with all P-415 EDGE upper receivers, Minuteman, Wonder, & Renegade upper receivers, P-308 upper receivers, and Revolution PD & Revolution DI upper receivers.
OEM replacement pins. We use these pins to mount all piston gas blocks to barrels. Once removed POF-USA suggests re-mounting all gas blocks with new taper pins.
Factory replacement gas plug assembly for P-308, P-415, P-416, and Revolution PD firearms. This plug is compatible with 2010 and later model POF-USA gas piston firearms.
These rings are located on the rear portion of your bolt. They create a seal inside the bolt carrier to catch gases. They use the built-up pressure to unlock the bolt after a round is fired.
Introducing POF-USA's 2-piece Hand Stop Kit. Black Anodize Aluminum 2-piece Design specifically manufactured for use on M-LOK compatible rail systems and includes all M-LOK mounting hardware.
This patented barrel nut is one of our most significant innovations. At 3" long, it completely encompasses the chamber and throat area of the barrel where expanding gas temperatures peak. It has 17 times more heat dissipation than a standard AR barrel nut.
The Micro B controls muzzle impulse for ultimate accuracy and soft recoil. It comes with a collar jam nut and five strike prongs. Two thread pitch options are available. One is 1/2x28 and the other is 5/8x24.
These charging handle assemblies are forged from 7075 aerospace grade aluminum and designed to fit in AR-15 pattern upper receivers. They are for use in all AR-15 pattern upper receivers.
OEM Replacement Spring. This part is intended for use in all standard Mil-spec AR-15 Extractors. This part is held in place inside the tail section of the extractor.
Our collar jam nuts are specifically designed to relieve unnecessary stress on the barrel. Simply tighten any muzzle device against this jam nut without the use of shims or crush washers. They are available in 1/2x28 or 5/8x24 thread pitchs.
