For Consistent and Crisp single stage 4.5 lb pull in Semi-auto or Full Auto use. This replaces your full auto trigger groups in all mil-spec M-16 weapon systems. Increases Accuracy and Controllability.
Our Full Auto Drop In Trigger design is based on our tried and true Drop In Trigger, and works with all Mil-Spec M-16 full auto weapon systems. Our Drop in full auto trigger module works with the mil-spec full auto sear. This single-stage, non-adjustable, drop-in trigger is pre-assembled in a hard anodized aluminum housing for immediate tactical applications right out of the box. Wire EDM cut from American A2 tool steel, the trigger, disconnect, and hammer are all nitride heat-treated to 70 Rockwell case hardness for ultimate strength and corrosion resistance. When assembled, POF-USA’s signature rubber urethane feet keep the unit snug in the lower receiver.
Because it matters even more in Full Auto, POF-USA includes custom-fit stainless steel KNS Precision™ Anti-walk Pins that work in both standard M-16s and POF-USA’s ambidextrous lower receivers.
**Will not work with DPMS 308 lowers that have straight trigger guards or with Sig 716 lowers**
**Will not make your rifle into a fully automatic rifle, and that it is only to replace the fully automatic mil-spec trigger in an M-16 or otherwise a fully automatic lower receiver. All NFA rules apply**
You may also like
Replaced a mil-spec GI trigger during a complete M-16 rebuild, also with a POF 415 upper. Works flawlessly, really smooth trigger pull that is much lighter and shorter than the GI trigger; this takes some getting used to.
Read the installation instructions – unlike mil-spec lower rebuild procedures, this trigger has to be installed first, before the selector core and levers. Also keep an eye on the rubber feet on the bottom of the trigger module, they pop out easily before they are installed, and need to be compressed slightly against the bottom of the receiver when you install the trigger and hammer pins.